# What Does Negative Voltage Mean on a Multimeter

While measuring a circuit’s voltage, you may have noticed a negative voltage reading on your multimeter. So don’t be confused; we will explain to you the reason behind this negative voltage. A negative voltage is just an error or it’s applicable you might also say about this. In this article we will discuss what does negative voltage mean on a Multimeter.

The negative voltage is basically used in transistors, in the telecom industry, and also in amplifiers to control overheating electrochemical reactions. As you know, -48 V is used in the telecom industry.

This may be confusing for learners, but it’s necessary to understand this fault. If you want to keep working on a multimeter then you need to know first about its functions. It is a type of voltage that is less than zero. Another says it is a voltage that is pointing in the opposite direction of the positive (+).

## A negative voltage is used in electrical systems to control the power flow.

Multimeter reading indicates that there is currently flowing in the opposite direction of positive.

## The Meter is set to reverse polarity.

This is a common problem with learners when they measure DC voltage. To fix this, you can just switch the lead at measuring points. The red cord will be connected with the positive measurement point and the black one with the negative dot.

A break in the circuit will cause a short circuit.

You will need to find the breakage in the circuit and repair the circuit breaker. Now you should first check the transformer and the diode.

You’re measuring the voltage that is negative relative to the ground.

If you are measuring the voltage between two points in a circuit with respect to ground, one point is at ground potential and another one is at volts.

Here’s the multimeter it’s set to measure DC voltage and there are two batteries. One of them is pretty strange so it’s a rechargeable battery, a triple – a nick metal hot rod.

Two wires connect with a multimeter, the red one is positive and the black one is negative. So let’s take measurement red goes the plus and the multimeter shows volts DC. Take the battery and put red wire on plus + and negative on minus –, the multimeter shows negative volts. Now let’s reverse, you can change the sides of wires and put black on the plus and red on the minus, it shows positive. It means when a multimeter shows negative voltage you need to reverse the direction of multimeter wires.

## How to find Positive and Negative wires.

This is a very simple method, first, you need to get a glass of water then you need to immerse the two ends of wires of the power source inside this glass of water then you need to switch on your power source. After a few seconds, your negative pole will start creating bubbles. So from this method, you can easily identify the negative pole which is creating bubbles.

## Use Of Multimeter

We will tell you to properly use a multimeter and we will be covering how to measure DC voltage, AC voltage, resistance, continuity, and also how to measure amperes.

We will tell you how you can calculate the watts and amps for any device.

Let’s start with DC voltage. Basically, the DC voltage in devices we use each day are batteries so pretty much all devices that use a battery run on DC voltage,